Contents
A stop loss is an order to close a position once price reaches a set level against you. It’s the point where the trade idea is proven wrong.
How a stop loss works
Most stop losses are stop-market orders: until price reaches the level there’s no order in the book, and once it does, it becomes a market order and closes the position at the best available price. That’s why in a fast market a stop can fill worse than its level — that’s slippage. A stop-limit doesn’t slip, but it may not fill at all, leaving the position open.
Stop first, size second
Trade risk = distance from entry to stop × point value × number of contracts. One NQ point is $20, one MNQ point is $2. A 10-point stop on one MNQ is $20 of risk; on one NQ it’s $200. The right order: put the stop where the idea is wrong, then size the position to your allowed risk with the position size calculator — not the other way round.
Where to place the stop
- Beyond the level that cancels the idea, not at a round “10 points”.
- Not right behind the obvious extreme. Other traders’ stops sit there and price often gets pushed through — that’s a liquidity sweep. I put my stop beyond the sweep’s wick, not inside it.
- With room for noise. Too tight and normal wiggles take you out; too wide and you need a tiny size.
Common mistakes
- Moving the stop further away as price approaches it. That turns limited risk into unlimited risk.
- Trading with a “mental” stop. In a sharp move it’s too late to decide.
- Counting risk in points and forgetting the number of contracts.
Related terms
FAQ
What is a stop loss in simple terms?
An order placed in advance that closes your trade if price reaches a level against you. It caps the trade’s loss.
Why did my stop fill worse than its level?
A stop-market turns into a market order at its level and takes size at the best available prices. In a fast market part of it fills at the next prices — that’s slippage.
How do I size a position for my stop?
Divide your allowed dollar risk by the risk of one contract: stop distance in points × point value. The position size calculator does this for NQ, MNQ, ES and MES.
What order flow is — the basics in plain words →
← All glossary terms